Enron Mail |
Good afternoon!
No, this isn't a new tip - just a follow-up on the one I sent this morning. I received some good responses and wanted to pass a couple of them along. Kevin wrote to say that this tip works like a charm, except for one thing: he's had trouble with the router bit not being perfectly centered on the base, so his dadoes have ended up less than perfect. I referred to this briefly at the end of the tip, but here's a quick solution for avoiding the problem. Before routing the dado in the gauge, first mark a point on the base of your router. (I simply add a piece of masking tape since it's easy to see.) Then when routing the gauge (and later, the panel), always keep this mark against the straightedge. Your dadoes should be right on. Another email came in from Mike, who suggested making two alignment gauges. Then you can clamp one at each end of the workpiece before you clamp the straightedge fence down. This prevents the "wiggling" that often occurs when one end is clamped before the other. Great tip! A big thanks to all who have been sending in suggestions. It's great to hear that so many people are enjoying the tips. Talk to you again in a few weeks. Jon Garbison On-line Editor Woodsmith Visit our other woodworking and home improvement sites: 100+ Woodworking Plans: <http://www.PlansNOW.com/< Woodsmith Magazine: <http://www.Woodsmith.com/< ShopNotes Magazine: <http://www.ShopNotes.com/< Workbench Magazine: <http://www.WorkbenchMagazine.com/< Kits, Jigs, Tools, Project Plans: <http://www.WoodsmithStore.com/< Back Issues: <http://www.BackIssueStore.com/< Woodworking Forums: <http://www.Forums.WoodNet.net/< <-------------------------------------------------------< TO CHANGE YOUR EMAIL ADDRESS or resubscribe, sign up again at <http://www.WoodworkingTips.com/< TO UNSUBSCRIBE, send EMPTY email message to: <leave-woodtips-30771C@listserv.augusthome.com< NOTE: Your subscribed email address is <dfarmer@ect.enron.com<
|