Enron Mail |
Hi Mark,
I discussed the issue of releasing fault related information to our customers (specifically, Zilka) with Kevin. We feel that the information about which statistical counters increment during specific faults can be released to them. When it comes to specific faults and the circumstances under which they occur, the only documentation that goes into any detail is the controller document published by the controls group in Rheine. We don't want to release the entire document (for obvious reasons) and the information on the cause of the faults and related parametes is in the above mentioned document. (We got the information for the "Error identification" column from Section 2.2 of "Software Description EW1.5 Bachmann-M1".)To interpret this information, they would also need the parameter list and we do have parameter lists specific to Mill Run and Somerset that are being released through document control this week. (I've attached a master parameter list that is not specific to a given site. The values in this list may not be exactly the same as the actual settings at Mill Run/Somerset). (This document can be released to the customer) (This document can be released BUT it is not specific to the customer's site. The site specific lists scheduled to be released this week...) (You can use this to answer specific questions that the customer has but DO NOT release this to the customer- for internal use only.) I hope this information helps out in your discussion with Zilka. -Garth
|